6.7L Cummins Forum

HeberRam · #1 (**permalink**) 07-04-2008, 06:53 PM

Does anyone know the tranny fluid capacity of the 6.7 auto? Going to change fluid and adding a PLM deep pan. The pan holds 4 extra qts., need to know about how much the stock tranny holds to buy enough fluid for the change.

HeberRam · #2 (**permalink**) 07-08-2008, 01:45 PM

well since I just got through installing the PLM deep pan, I will answer my own question. The tranny holds 7 qts. (not counting the torque converter). So to service ( cahnge filter etc. ) plan on draing 7qts. I put the deep pan on, put 4qts. for the new pan and 7 qts. for the replacement and alls good. Will be towing in a couple of weeks and I'll let you know how much temp dropped over stock pan???

Squid · #3 (**permalink**) 07-08-2008, 10:43 PM

I would have sworn I did respond here because I had found this for you Dodge Ram Fluid Capacities ....................maybe I didn't hit the post button? Sorry, but I post stuff all the time that gets no response? LOL

jarbach · #4 (**permalink**) 03-25-2009, 10:55 PM

Did you change the transmission filter as well? If so, was it difficult? I'm getting ready to put AMSOIL in my 6.7L and the trans filter is listed at $47!!

Thanks,

DWRDodge6.7 · #5 (**permalink**) 03-27-2009, 11:38 AM

There are two filters in the 68RFE pan. The small screw on type filters the fluid returning from the cooler. There is also a large traditional type trans filter which filters the fluid as it is drawn out of the pan by the pump. The large one is about $40.00, the small one about $10.00.

Squid · #6 (**permalink**) 03-27-2009, 06:43 PM

Try Genos Garage. They have a lot better prices and you don't have to leave the house. Dodge Cummins and Ford Power Stroke Diesel Truck Accessories - Geno's Garage

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode