6.7L Cummins Forum

Anyone have a good place to mount a brake controller? I have a Prodigy and the place I had it in the 1500 is now occupied by the adjustable pedal switch on the 2500. I'm not keen on drilling holes in the dash...

__________________
2009 Ram 2500,QC, 6.7L, Auto-6, 4X4, Laramie
2006 Hummer H3, 3.5L, Adventure PKG
1986 GMC Sierra Classic, 5.7L

I have mine (Prodigy) where my right knee is. It is a good spot for adjusting and braking while driving.

__________________
2008 Dodge 2500HD 6.7L 4X4 Laramie
Edge insight, Amp tailgate step, 4" Boss Bars, rear air bags with compressor, spray in bed liner

I'll have to get photos of it, I installed mine where the ash tray is, Actually to the lid with a couple of door hinges. It is out of the way and easy to see, you can still use the cup holders.

__________________
07.5 3500 Quad, SRW, 4X4, Laramie, Leathered, Dark Metallic Gray, 6.7, 68RFE, 20K Reese, Ride Rite's, 2 Viair air compressors, Bully steps, Kleinn Locomotive air horns (5 in all), Billet polished locking fuel door, 'A' pillar mount Auto Meter Pryo, PML X-deep trans pan
06 Durango 285 RL 5'er Lifted by KZ

Finally. Here are the pictures of the Prodigy controller mount.

Attached Thumbnails

 

__________________
07.5 3500 Quad, SRW, 4X4, Laramie, Leathered, Dark Metallic Gray, 6.7, 68RFE, 20K Reese, Ride Rite's, 2 Viair air compressors, Bully steps, Kleinn Locomotive air horns (5 in all), Billet polished locking fuel door, 'A' pillar mount Auto Meter Pryo, PML X-deep trans pan
06 Durango 285 RL 5'er Lifted by KZ

Sweet...thanks for the pic Garlic, I like that location!

__________________
2009 Ram 2500,QC, 6.7L, Auto-6, 4X4, Laramie
2006 Hummer H3, 3.5L, Adventure PKG
1986 GMC Sierra Classic, 5.7L

It seemed to be the only place in the cab for it so it could set at the proper angle. My GPS sits on it some times and you can still use the cup holders.

__________________
07.5 3500 Quad, SRW, 4X4, Laramie, Leathered, Dark Metallic Gray, 6.7, 68RFE, 20K Reese, Ride Rite's, 2 Viair air compressors, Bully steps, Kleinn Locomotive air horns (5 in all), Billet polished locking fuel door, 'A' pillar mount Auto Meter Pryo, PML X-deep trans pan
06 Durango 285 RL 5'er Lifted by KZ

Interesting bends in the hinges. Gets the job done though. I put mine on the left lower dash about in line with my left knee. I just used industrial strength hook and loop and it has worked well. I am fairly long legged so I have only had to move the seat back a touch and the peddles toward me a little.

May seem crazy to some of you but mine is mounted behind the cover underneath the steering column and upside down so that I can adjust it as well. I only pull my travel trailer though occasionally and did not want to hit it with my knee. It is accessible if i just lean forward a bit, hard to visualize I know but it works and the interior is still clear of aftermarket pieces.