6.7L Cummins Forum

Hey has anyone else out there had problems with the garage door openers saying they programmed but not actually working? I have been going by the book....step..by..step..... to program mine to an "overhead door company" remote. Any suggestions guys?

After a couple of times I got my to work in my trucks over head. Of course I can only temporary park in in the garage cause it sticks out by 2ft. beyond the door! Sorry I have no suggestions for ya.

Mine acts as if it doens't have power to it. Took it to the dealer and they said it was ok? Taking it back soon

You all can get your trucks in your garage?

__________________

2007.5 Dodge Ram 3500 HD,QC, 6.7L Cummins, 6speed Auto, 4X4, Bighorn Edition.
Click for installs: Carr Steps PML Diff Cover Edge Juice with Attitude Volant Intake Hankook ATM RF10

yep got a 23' garage. have about 2 foot room it is tight but it fits. If I ever buy another house it wil have a 30' garage

This instruction help me to get mine to work Good Luck


To program a built-in-car transmitter to a rolling code garage door opener (Genie rolling code is called Intellicode, Liftmaster/Sears is called Security plus), you should take the following steps.

Clear out anything previously programmed into the in-car system from the factory by holding down on the 2-outside buttons simultaneously, until the in-car LED starts flashing rapidly. This may take up to a minute (in most cases, the key should be on auxilary, and/or the car door must be shut).
Decide which button you want to make to be your in-car garage door transmitter. Hold your transmitter up near the selected button, pressing both the garage door remote and the selected in-car transmitter button simultaneously. Hold down on the buttons until the in-car, LED light flashes rapidly. This sets the in-car remote transmitter to be your garage door openers make transmitter, but you are not done. You now need to make this in-car transmitter your personal transmitter.
Go to the Learn Button on your garage door opener. The button is usually next to the area where the floppy antenna is connected to the motor head. With Genie it is most often behind the light lens, and an indicator light flashes red when pressed. With Sears or Liftmaster (Chamberlain) it is near, or part of, the terminal screw board, and is a red, green or purple square button with a green, amber or purple indicator light. Press this learn button momentarily. The indicator light will turn on and blink if Genie or otherwise stay lit. For Genie systems, go back to the in-car transmitter button you programmed and press this button 3 or 4 times, or until the door starts moving. This should set your in-car transmitter to your garage door opener. For Liftmaster, Sears, or Linear Megacode press and hold the in-car button you programmed until the garage opener light flashes. Your in-car is now programmed to operate your door.